Great-plains 2015 Operator Manual User Manual download pdf (Page 10)

2015 Three-Point Soybean Machine 173-088M 4/18/05

Great Plains Mfg., Inc.

Section 2 Assembly Instructions & Set-Up

Right Hand Gauge Wheel

Refer to Figure 2-1:

The right hand (#3) gauge wheel is installed the same as

the left hand (#1) detailed in under "Left Hand Gauge

Wheel" page 7. Take this same dimension from the oth-

er end and mark where the right hand (#3) gauge wheel

should be located.

Drive installation

Refer to Figure 2-2:

1. Locate the 7/8” hex jack shaft (#1).

IMPORTANT: The following shaft installation procedure

will minimize damaging preloading of the sprocket and

bearing assembly (#2).

2. Starting at the gauge wheel, slide the shaft through

the 12 tooth sprocket and bearing assembly (#2). If

the shaft naturally aligns itself with the 7/8” hex bore

bearing (#3), the sprocket and bearing assemblies

are properly in place.

IMPORTANT: If the shaft is too high or to low to enter

bearing (#3), loosen the flangette bolts and slide bearing

(#3) up or down until the height matches the shaft. If the

shaft is too far forward or backward to enter bearing (#3).

Slide the sprocket & bearing assembly (#2) in its mount-

ing holes on the gauge wheel mount extended wing as

needed until the 7/8” hex shaft easily slips into the bear-

Gauge Wheel Mount On To Frame

Figure 2-1

13504

ing mounted on the drill frame. The shaft must be level up

and down, and straight front to back. Tighten both sets of

bearing bolts.

Refer to Figure 2-3

a. Slide the 7/8” hex shaft (#1) back out enough to

slip on the 12 tooth sprocket (#2) if it is not al-

ready in place.

Drive Shaft Installation

Figure 2-2

13505

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 29 30

No comments

Great-plains 2015 Operator Manual User Manual Page 10