Great-plains 2551SC Predelivery Manual User Manual download pdf (Page 11)

10/10/2013 Table of Contents Index 540-179Q

Great Plains Manufacturing, Inc. Table of Contents Index 7

Assembly

Hub & Wheel

6. After un-crating the machine, place the center frame in the

center of work area by setting the front on stands as

shown.

Refer to Figure 4

Note: All bolts are pre-installed on the unit in there proper loca-

tion. Bolts will need to be removed and then re-installed

during assembly. It is important to attach hub & wheel as-

sembly , then hitch assembly , See “Hitch” on page 7

before attaching or folding wings because machine could

tip over.

7. Attach rear hub & wheel assemblies into outside tube of

torque tube , secure with 5/16x2 13/16 pin and 1/8x1

cotter pin.

8. If machine is equipped with the optional dual tire transport

assembly , attach to inside tube of torque tube with 5/

16x2 13/16 pin and 1/8x1 cotter pin.

9. Bend cotter pins to secure.

Hitch

Refer to Figure 5

10. Attach the hitch assembly to front of center frame with

3/4x2 hex bolts , 3/4 lock washers and 3/4 nuts.

11. Remove pin from jack , swing down and re-install pin.

This will help stabilize machine during the rest of assembly.

Bolt may be tightened to specs, See “Torque Values

Chart” on page 12.

Figure 4

Hub & Wheel

42808

1 5

2 3

Figure 5

Hitch

42809

5 6

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

No comments

Great-plains 2551SC Predelivery Manual User Manual Page 11