Great-plains 3S-3000F Operator Manual v2 User Manual download pdf (Page 16)

Section 1 Drill Preparation and Setup

3S-3000 Three-Section Folding Drill 195-110M-A 11/9/07

Great Plains Mfg., Inc.

Transfer Drive Shaft Front to Rear Adjustment

Figure 1-6

15620

2. Align Transfer Drive Shaft

After the wing boxes are properly aligned, the transfer

drive shaft must be aligned so the pair of break-away jaws

have full engagement and are concentric. The 7/8" hex

drive shafts holding the clutch jaws should not contact

each other when the wing boxes are properly aligned and

back against their stop. Place a 4x4 or similar sized block

ahead of the wing gauge wheels and pull forward or push

the wing box frames back until the toolbar stop bolt is ﬁrm-

ly against the stop plate on the center box frame.

To align the clutch jaws in the front to rear direction, loosen

the two 5/16" (#1) bolts which hold the 7/8" hex bearing

ﬂangettes (#2) and slide the bearing assembly in the de-

sired direction, as shown in Figure 1-6.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 72 73

No comments

Great-plains 3S-3000F Operator Manual v2 User Manual Page 16