Great-plains 4000TT Operator Manual User Manual download pdf (Page 24)

20 1200-4000TT Great Plains Manufacturing, Inc.

586-201M 02/11/2014

Transport Locks

Refer to Figure 8

11. Once the cylinders are connected, raise the unit

completly. If the transport locks are in place,

remove them at this time.

12. Store the transport locks in hole of the lift mecha-

nism link.

Wing Fold

Refer to Figure 9

13. If wing stop pins are installed remove pins from

wing stop clevis .

14. Install pin in storage tube on wing stop.

15. Once the transport locks and wing stop pins are

removed, unfold the wings (if folding unit).

Note: Make sure no one is under the wings during the un-

folding process. Watch for leaks and make sure

hoses do not get pinched during the initial unfolding

process.

16. Once the machine is unfolded, raise and lower the

machine several times to purge air from the lift sys-

tem. Again, watch for any leaks and tighten if neces-

sary.

Pre-Leveling of Machine

Note: Pre-leveling of machine should be done on a good

level surface.

Front to Rear Leveling

Refer to Figure 10

17. Lower machine so front coulters gangs are 1-2” off of

ground. Loosen jam nut with turnbuckle wrench

(stored on center tube pegs of hitch). Adjust the turn-

buckle at the front of machine to level it front to

back. (Shorten to bring front down, extend to bring

front up).

18. When the front coulter gangs are the same distance

off ground as rear coulter gangs retighten jam nut .

Figure 8

Transport Locks

42066

Figure 9

Wing Fold Pins

42067

Figure 10

Hitch Turnbuckle Adjustment

42069

1 2

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 41 42

Comments to this Manuals

No comments

Great-plains 4000TT Operator Manual User Manual Page 24

Comments to this Manuals

Related products and manuals for Gardening equipment Great-plains 4000TT Operator Manual