Great-plains PFH-20 Operator Manual User Manual download pdf (Page 9)

Section 1 Assembly and Setup

6/21/2004

PH-15, PH-20, PFH-15 and PFH-20 Coulter Command System 148-384M

Great Plains Mfg., Inc.

Figure 1-4

Gauge Wheel Lift Cylinder

18429

Gauge Wheel Lift Cylinder

Refer to Figure 1-3.

1. Install the base end of the lift cylinder (1) to gauge

wheel mount bracket with a 1/2 x 1 3/4 inch clevis pin

(2) and a 1/8 x 3/4 inch cotter pin (3) provided with the

cylinder.

NOTE: The ports on the cylinder should point away from

the depth sensing gauge wheel.

2. Place the rod end of the lift cylinder between the slot-

ted lugs on the gauge wheel arm. Place a ﬂat washer

(4) on the outside of each slotted lug on the gauge

wheel arm. Pin in place with a 1 1/2 x 2 3/4 inch clevis

pin (5) and a 1/8 x 3/4 inch cotter pin (3).

Figure 1-3

Gauge Wheel Lift Cylinder

18428

Speed Sensor

Refer to Figure 1-4.

1. Remove the tire and rim from the depth sensing wheel

and bolt the speed sensor plate (1) between the wheel

and rim.

2. Screw the speed sensor (2) to the sensor mounting

bracket at bottom of the gauge wheel with #6 x 1/2

inch pan head screws (3), lock washers (4) and ﬂat

washers (5).

3. Position sensor to just touch the speed sensor plate

(1) and tighten screws.

4. Route co-axial cable (6) from sensor, across gauge

wheel arms, and up the side opposite the tire.

5. Screw the end ﬁtting into the co-ax connector on top of

the sensor box (7).

6. Slide co-axial cable into notches at the bottom of

gauge wheel arms and fasten to the side of gauge

wheel arm with the cable tie mounts (8) and cable ties

(9). Make sure the cable does not rub anything as

depth sensing wheel moves up and down.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 25 26

Comments to this Manuals

No comments

Great-plains PFH-20 Operator Manual User Manual Page 9

Comments to this Manuals

Related products and manuals for Gardening equipment Great-plains PFH-20 Operator Manual