Great-plains TCN5313 Predelivery Manual User Manual download pdf (Page 12)

566-170Q 03/17/2014

8 TCN5107-5313 Great Plains Manufacturing, Inc.

Assembly

Gangs

Refer to Figure 5

Note: Folding models will be shipped with wings attached in

transport position, but shown in ﬁeld position or no wings

for clarity. The large bolts will be shipped either in frame

or part assemblies in proper locations. The smaller bolts

will be shipped in a box. See “Parts Manual for part num-

bers and description of parts. The gangs will come pre-

assembled on gang tube. Refer to machine layout in Ap-

pendix for proper gang placement.

18. Start by attaching the center gang bar assembly , with a

fork lift or overhead hoist with 3/4 x 2 hex bolts , 3/4 lock

washers and 3/4 nuts.

19. Carefully move the gang assemblies into the machine

so the c-ﬂexes are just under the gang bar mount assem-

bly as shown. Install a mounting pate above and

below gang tube. Secure with a 3/4 x 6 hex bolt (rear

hole of plate) and 3/4 lock nut. Now align holes of gang

bracket plate on bottom side od c-ﬂex, secure with 5/8 x

7 hex bolts , 5/8 lock washers and 5/8 nuts.

20. Bolts may be tightened to specs, See “Torque Values

Chart” on page 15.

21. Repeat same procedure for the wings after the hitch and

hydraulics have been installed so the wings may be

unfolded.

Truss, Depth Stop Tube & Wing Stop

Assembly

Refer to Figure 6

22. Attach rear of RH hitch truss and LH hitch truss with

1 1/4 x 8 1/2 Gr. 8 special thread bolt , 1 1/4 lock washer

and 1 1/4 nut. Secure middle plate with 3/4 x 2 1/2 hex

bolts , 3/4 lock washers and 3/4 nuts. Secure front plate

with 3/4 x 2 hex bolts , 3/4 lock washers and 3/4 nuts.

23. Slide front of depth stop assembly through square hole

of bracket welded on left side of LH truss. Align rear holes

of depth stop assembly on torque tube lever, secure

with 1/2 x 3 hex bolt , 1/2 lock washer and 1/2 nut.

24. Fasten wing stop to top plates of trusses with 5/8 x 1 1/

2 hex bolts and align holes as shown below.

25. Re-attach 5/8 x 2 bolt , 5/8 lock washers and 5/8 nuts.

26. Mount the manual pack to RH truss plate with 1/4 x

1 hex bolts , mini end press wheels , 1/4 lock wash-

ers and 1/4 nuts.

27. Bolt may be tightened to specs, See “Torque Values

Chart” on page 15.

Figure 5

Gangs

42043

1 6

Figure 6

Truss, Depth Stop & Wing Stop

42043

1 2

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 41 42

Comments to this Manuals

No comments

Great-plains TCN5313 Predelivery Manual User Manual Page 12

Comments to this Manuals

Related products and manuals for Gardening equipment Great-plains TCN5313 Predelivery Manual