Great-plains PFH-20 Operator Manual User Manual Page 10

  • Download
  • Add to my manuals
  • Print
  • Page
    / 26
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 9
8
Section 1 Assembly and Setup
PH-15, PH-20, PFH-15 and PFH-20 Coulter Command System 148-384M 6/21/2004
Great Plains Mfg., Inc.
Wiring Harness
Refer to Figure 1-5.
1. Route the wiring harness (7) through 8 x 8 inch hitch
tube and to the lift switch at the rear of the machine.
Plug into the lift switch and support the cable with ca-
ble tie mounts (8) and cable ties (9) or strap the cable
to the hydraulic hoses.
2. Plug the 4-pin connector of the wiring harness to sen-
sor box on the depth sensing wheel and support the
cable with cable mounts and ties.
3. Route the 9-pin connector through the spring hose
loop and to the tractor hitch. This will plug into the 9-
pin female connector from the control box extension
cable.
4. Plug the other three short leads into the leads from the
solenoids on the hydraulic control valves (10 and 11)
after they are installed.
Figure 1-5
Lift Switch and Wiring Harness
18430
Lift Switch
Refer to Figure 1-5.
1. Bolt the plunger activated lift switch (1) to the switch
mount located next to the left transport lift cylinder at
rear of the Precision Hitch transport frame with two
#10 x 3/4 inch pan head screws (2), flat washers (3),
lock washers (4) and nuts (5). Do not tighten screws at
this time.
2. Fasten rockshaft switch cam (6) to transport rockshaft
just below the lift switch. Position the cam so it con-
tacts the lift switch when hitch is raised and moves
away from the lift switch when hitch is lowered. Posi-
tion the worm gear screw on the cam mounting band
to the bottom of the rockshaft so it does not interfere
with the lift switch.
3. Adjust lift switch in the slotted holes so the plunger
moves in about 1/8 inch when the cam activates it and
tighten the #10 screws. Do not bottom out the plunger
on the lift switch.
4. Rotate the cam assembly so it hits the plunger when
the hitch is raised just enough to begin to pick the
openers off the ground.
Page view 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 25 26

Comments to this Manuals

No comments