Great-plains Simba Double Press 2013 Operator Manual User Manual download pdf (Page 26)

Simba Double Press

610-026M-ENG

 2013-01-25

4. Adjustment / Operation

4.4 Work Settings

In work the wing cylinders should be fully

extended. The gangs are able to oat over

any undulations on the ground due to their

oating frames.

Optimum performance has been found

to be achieved when the press roll rings

have worn away the painted nish leaving

a smooth shiny surface. When the press

roll rings are new or rusty, soil may tend to

pick up on the surface and blockage may

occur, this will reduce when the rings are

shiny again.

The Double Press should be run with the

chassis level front to rear by extending the

drawbar cylinder to the necessary position.

The cylinder should not be over extended

as this will remove the load on the front row

of rings which could lead to reduced drive

and hence blockage of the axles.

It is not necessary to tilt the Double Press onto

the transport wheels during headland turns

whether the machine is used independently

or in tandem with a disc cultivator. Normally,

the Double Press should be tilted sufciently

onto the rear roll for the tines to clear the

ground (at which point the rear axle wheels

will still be clear of ground contact).

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 39 40

No comments

Great-plains Simba Double Press 2013 Operator Manual User Manual Page 26