Great-plains ADI445 Operator Manual User Manual download pdf (Page 22)

Section 1 Assembly and Setup

Model 2250 Air Drill Implement 160-192M 5/11/05

Great Plains Mfg., Inc.

Distribution Towers and Hoses

Refer to Figure 1-19 for tower mounting locations. Choose

implement conﬁguration to determine tower placement.

1. Refer to Figure 1-17, install a tower support bracket at

each location using the 1/2” u-bolt (#1), 1/2” lock

washers (#2), and 1/2” nuts (#3)

NOTE: For best results, distribution towers should be

mounted as vertically as possible. A tower that leans

signiﬁcantly to one side may cause uneven distribu-

tion, particularly when operating on hillsides.

Mounting Tower

Figure 1-17

14546

2. Position a tower on the bracket and secure with 2 1/2”

x 2 1/2” u-bolts. The bottom of the lower round plate

should be approximately 31 1/2 inches above the

frame members. The tower should be turned so that

inlet tube is pointed toward the center of the imple-

ment. The center tower inlet should face the front of

the implement, see Figure 1-18.

Tower Positioning

Figure 1-18

14499

Frame Leveling Measurement

Figure 1-16

15207

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 47 48

No comments

Great-plains ADI445 Operator Manual User Manual Page 22