Great-plains TL350 Operator Manual User Manual download pdf (Page 22)

22

Simba TL

605-039M-ENG

 2013-02-27

4. Adjustment / Operation

4.9 Work Instructions

Driving speed

The Simba TL can be driven at speeds of

up to 12 km/h.

This depends on the eld conditions (type

of soil, surface trash, etc.).

Drive more slowly if the conditions are dif-

cult or a rmer nish is required.

Turning:

Before turning, the machine should

be lifted out of work while driving.

Likewise, it should lowered back

into work once the turn has been

completed.

4.10 Parking the machine

In order to avoid damage as a result of

moisture, the machine should be parked, if

possible, indoors or under cover.

When manoeuvring the machine,

pay attention to your surroundings.

Ensure that nobody is in the

manoeuvring area (watch for

children!).

1 Park the machine on level and solid

ground.

2 Move the roller into its lowest setting

(ie oat setting) by removing the shims

from the front side of the depth control

rod. This is to ensure the machine

doesn‘t tip backwards when unhitched.

3 Lower the machine onto the tines

ensuring that it is stable.

4 Remove the toplink and lower the link

arms so that pins can be removed.

5 Switch off the tractor.

4.11 Using Shims

Before using shims to alter machine settings

ensure the machine is stationary and the

tractor is turned off with the keys out. Ensure

that all operators are clear of the machine

and that no load is being held on any existing

shims in the depth control rod.

To t the shims hold them by the handle and,

using a rm action, clip them onto the rod

as shown in Fig. 4.09. They are removed by

using a nger to pull rmly on the handle.

Check the depth control rod for

damage and debris before tting

shims.

Only attempt to add or remove

shims using the handle. Trying to

manipulate shims using the jaws

could result in injury.

When changing machine settings

ensure both sides of the machine

mirror each other. The left hand

adjuster should contain the same

amount of shims as the right, for

example. Failure to do this could

result in damage to the machine.

Fig. 4.09: Shims

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 31 32

Comments to this Manuals

No comments