Great-plains TSF1290 Operator Manual User Manual Page 67
- Page / 96
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Great Plains Manufacturing, Inc. Maintenance and Lubrication 63
05/10/2012 500-641M
Filter Maintenance
There are two filters on the sprayer. One is a canister
type that filters the water entering the tank and the other
is a Whirlfilter® that filters the chemical solution being
sprayed.
These need to be cleaned seasonally, or sooner if flow
restriction is observed.
Clean-out the solution Whirlfilter®
Refer to Figure 54
1. Fill the sprayer tank with water and turn the pump on.
2. With the pump running, slowly open the clean-out
valve and allow the grit to flow out into a bucket.
Clean out the solution Whirlfilter® only when the
sprayer tank is filled with water and no chemical has
been added.
3. Close the clean-out valve and turn off the pump.
4. Dispose of the grit and water in the same manner
described on the manufacturer’s label of the latest
chemical used in the sprayer.
Clean Out Tank Fill Filter
Wear chemical gloves and protective clothing. Although used
for adding clean water, the chemical mix in the main tank can
back-wash into this assembly.
Refer to Figure 55
1. Start with an empty sprayer tank.
2. Position a bucket under the plug in the sump cap
of the filter. Remove the plug and allow the grit to
fall out.
3. Screw the plug back in using pipe thread sealant to
seal the plug.
4. Dispose of the grit and water in the same manner
described on the manufacturer’s label of the latest
chemical used in the sprayer.
If draining the filter does not improve flow:
5. Unscrew the entire sump cap . Remove it slowly
and save the gasket .
6. Remove the filter element . Clean or replace it.
7. Re-assemble the filter. No thread sealant is required
on the main cap threads.
Figure 54
Whirlfilter Clean-Out Valve
15787
Figure 55
Tank Inlet Filter
21808
2
4
1
3
1
2
2
3
4
- Operator Manual 1
- Table of Contents 3
- Important Safety Information 5
- Wear Protective Equipment 6
- Handle Chemicals Properly 7
- Confined Space 8
- Use A Safety Chain 8
- Keep Riders Off Machinery 8
- Use Safety Lights and Devices 8
- Check for Overhead Lines 9
- Transport Machinery Safely 9
- Shutdown and Storage 9
- Practice Safe Maintenance 10
- Prepare for Emergencies 10
- Tire Safety 10
- Safety At All Times 11
- Safety Reflectors and Decals 12
- 818-265C 13
- Daytime Reflectors 13
- 818-267C 13
- Amber Reflectors 13
- 500-641M 05/10/2012 14
- 05/10/2012 500-641M 15
- EXCESSIVE SPEED HAZARD 17
- 818-381C 20
- 818-304C 20
- Introduction 21
- Owner Assistance 22
- Preparation and Setup 23
- Hitching with Hydraulic Pump 24
- Axle Spacing 25
- Electrical Connections 26
- Connection Comment 26
- Hydraulic Hookup 27
- Tractor / PTO Shaft Hookup 28
- Leveling Sprayer 29
- Locking System Setup 31
- Hydraulic Pump Setup 31
- Electrical Installation 32
- Raven SCS 450 33
- Hydraulic Valve Control 34
- Foam Marker Control (Option) 34
- Spraying Setup 35
- Manual Throttle Valve 36
- Sprayer Calibration 37
- Operations 40
- Using Hand Wash Tank 41
- Figure 28 44
- Sprayer Tank Plumbing 44
- Operations 41 45
- Figure 29 45
- Boom Plumbing System 45
- Filling Tanks 46
- Filling the Flush Tank 47
- Filling the Main Tank 47
- Adding Chemicals 50
- Inducting Chemicals (Option) 51
- Agitation 52
- Boom Operations 53
- Operating Pump 56
- Unloading Materials 56
- Tank and Boom Flush 57
- Adjustments 61
- Axle Wheel Spacing Adjustment 62
- Break Away Spring 63
- Troubleshooting 64
- Maintenance and Lubrication 66
- Filter Maintenance 67
- Shear Bolt 68
- Pump Maintenance & Repair 69
- Elevator Slide 73
- Quad-Jet Agitators 73
- Tank Entry 74
- Lubrication 75
- Seasonally 77
- Autoboom 78
- Axles and Wheels 78
- Calibration Accessories 79
- Chemical Inductor 79
- High Volume Foam Marker 79
- Gauge Protector 80
- Hitches (Hydraulic Pump Only) 80
- Open Center Hydraulic Kit 80
- Speed Sensors 82
- Appendix 83
- Torque Values 84
- Valve Port Function 85
- 60-Foot Sections 87
- Raven G1 Autoboom Hydraulics 88
- Warranty 89
- Tire Pressure and Torque 92
- Salina, Kansas 67402-5060 USA 96
Related products and manuals for Gardening equipment Great-plains TSF1290 Operator Manual
(5 pages)
(70 pages)© 2020, manymanuals.com. All rights reserved. | 0.166 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals