Great-plains DVN8324 Assembly Manual User Manual download pdf (Page 38)

34 8315-8324DVN Great Plains Manufacturing, Inc.

550-466Q-ENG 11/25/2013

Refer to Figure 29

Connect Wiring Harness

181.Slide rubber end piece back from outer casing of

plug.

182.Remove screws from outer casing of European light

harness plug . Pull outer casing apart.

Note: Be sure to hook black wire of retract wire harness

to keyed power terminal on rear of plug . See

owners manual of tractor to determine which ter-

minal to hook black wire to. If hooked to constant

power terminal, this will decrease battery life as

solenoids will cycle constantly.

183.Thread retract wire harness through rubber end

piece starting with smaller ends.

184.Remove the two screws holding the metal plate .

185.Loosen screw (terminal 3), in retract wire harness

plug , slide white wire along side of existing white

wire (terminal 3) and re-tighten screw .

186.Repeat same procedure for black wire.

187.Re-connect the metal bar with the two screws .

188.Align plug in bottom of outer casing.

Note: Be sure plug and slot in casing are properly

aligned, otherwise casing will not ﬁt correctly.

189.Re-install screw to secure outer casing .

190.Slide rubber end piece back onto back side of outer

casing

Figure 29

Lighting Connector (European)

41926

1 2

5 4

4 5

5 4

3 2

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 73 74

No comments

Great-plains DVN8324 Assembly Manual User Manual Page 38