Great-plains NTA3007HD Predelivery Manual User Manual download pdf (Page 63)

Assembly 59

03/29/2010 166-207Q

Electric Harness (Monitor)

(see Parts Manual section: Monitor)

Refer to Figure 108

Locate and install system components as shown on the

diagram on the Quick Start Guide.

Print copy of:

DICKEY-john

IntelliAg

Quick Start Guide at:

http://www.greatplainsmfg.com/manuals/pdf/nta907qsg.pdf

Types of modules:

WSMT (Working Set Master) main system module -

inputs for bin, RPM, and other sensors.

WSMB-18R (Working Set Member) slave modules to the

master - monitors up to 18 rows.

WSMB-POM (Working Set Member) slave module to the

master - outputs for solenoids.

1. Main harness should be routed down LEFT PULL-

BAR with hydraulic hoses.

2. Route harnesses from module to module as shown

on the Quick Start Guide.

3. WSMB-18R modules should be installed with the

lowest serial number located on the left side of the

drill. This will make it easier to auto conﬁgure the

modules later.

4. Make sure harnesses are tied up and out of the way

of any moving parts and have sufﬁcient slack so

wires are not pulled tight.

5. All modules should be mounted so the connectors

are pointed down to prevent moisture ingress.

6. Make sure the CAN terminator is installed on the

end of the right harness.

Refer to Figure 109

Electric (Lights)

see Parts Manual section: International Lights

Figure 108

Electric Harness (Monitor)

29552

Figure 109

Lights

29432

27080

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 69 70

Comments to this Manuals

No comments

Great-plains NTA3007HD Predelivery Manual User Manual Page 63

Comments to this Manuals

Related products and manuals for Gardening equipment Great-plains NTA3007HD Predelivery Manual