Great-plains DVN8324 Operator Manual User Manual Page 60
- Page / 78
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
550-466M 11/25/2013
56 8315-8324DVN Great Plains Manufacturing, Inc.
Troubleshooting
General Performance
Problem Cause Solution
Rear Shanks Leaving
Groove
Rear of machine running too deep.
Coulter/disc gangs too deep.
Drag set incorrectly.
Operating machine too fast.
Level machine from front to rear with turn-
buckle, See “Front to Rear Leveling” on
page 37
Raise disc gangs.
Reset drag, See “Rear Attachment Set-
tings” on page 40.
Slow down (9-11 km/h)/(6-7 m/h).
Leaving Ridges On
The Outside
Wings not level.
Lift cylinders out of phase.
Leaking wing lift cylinder.
Drag set Incorrectly.
Operating machine too fast.
Adjust eyebolt at rear of wing cylinders to
level wings. See “Side to Side Leveling”on
page 38.
Rephase lift cylinders.
Repair or replace leaky cylinder, See pages
34-37 of “Parts Manual”.
Reset drag, See “Rear Attachment Set-
tings” on page 40.
Slow down (6-7 m/h)/(9-11 km/h)
Wings Not Penetrating Wings not level.
Coulter/disc gangs too deep.
Wing gangs deeper than center gangs.
Fold cylinder nor fully extended.
Adjust eyebolt at rear of wing cylinders to
level wings. See “Side to Side Leveling”on
page 38.
Raise disc gangs.
Rephase gang circuit.
Fully extend cylinders.
One Wing Running
Deeper Than The
Other
Wings not level.
Leaking wing lift cylinder.
Wing cylinder in wrong sequence.
Improper tire pressure.
Adjust eyebolt at rear of wing cylinders to
level wings. See “Side to Side Leveling”on
page 38.
Repair or replace leaky cylinder, See pages
34-37 of “Parts Manual”.
Repair or replace leaky cylinder, See pages
26-27 of “Parts Manual”.
Set air pressure, See “Tire Inflation Chart”
on page 64.
Both Wings Running
Too Deep
Wings not level.
Improper tire pressure.
Adjust eyebolt at rear of wing cylinders to
level wings. See “Side to Side Leveling”on
page 38.
Set air pressure, See “Tire Inflation Chart”
on page 64.
Whole Machine Runs
Deeper
Leaking depth stop cartridge.
Leaking master lift cylinder.
Replace cartridge.
Repair or replace leaky cylinder, See pages
26-27 of “Parts Manual”.
Center & One Wing
Run Deeper
Leaking master lift cylinder. Repair or replace leaky cylinder, See pages
26-27 of “Parts Manual”.
- Operator Manual 1
- Table of Contents Index 2
- Table of Contents 3
- Equipment Identification 5
- Machine Record 6
- Introduction 7
- Description of Unit 7
- Using This Manual 8
- Owner Assistance 8
- Important Safety Information 9
- Wear Protective Equipment 10
- Use Safety Chains 10
- Avoid High Pressure Fluids 10
- Keep Riders Off Machinery 10
- Tire Safety 11
- Use Safety Lights and Devices 11
- Transport Machinery Safely 11
- Shutdown and Storage 11
- Practice Safe Maintenance 12
- Safety At All Times 13
- Accident Prevention 13
- Safety Decals and Lights 14
- Reflectors: Fluorescent Panels 15
- Reflectors: Red 15
- Reflectors: Orange 15
- EXCESSIVE SPEED HAZARD 16
- Danger: Crush 17
- Danger: Electrocution 17
- Warning: Wing Crushing 18
- Warning: High Pressure Fluid 18
- Warning: Hand Pinch 18
- 848-530C REV A 18
- Caution: Read Operator Manual 19
- Caution: Tires Not A Step 19
- Notice: Transport Lock 19
- Danger: Cutting of Foot 19
- Preparation and Setup 20
- 11/25/2013 550-466M 21
- Clevis Hitch 22
- Category III Hitch 22
- Electrical Hookup 23
- Brake Hook-up (Option) 24
- Air Brake Hook-up 25
- Hydraulic Brake Hook-up 26
- Operating Instructions 27
- Unfolding and Folding 28
- Unfolding 30
- 550-466M 11/25/2013 32
- Lowering 33
- Transporting the Discovator 35
- Brake Operation (option) 37
- Transport 39
- Field Operation 40
- First Time Field Adjustments 41
- Side to Side Leveling 42
- Disc Gang Depth Calibration 42
- Scraper Settings 43
- Rear Attachment Settings 44
- Coil Tine Settings 45
- Reel Settings 45
- Unfolded Storage 46
- Maintenance and Lubrication 47
- Maintenance Lift Lock 48
- Wheel Bearing Hub 49
- All Hinge Points 49
- Brake Maintenance (Option) 50
- Air Brake Maintenance 52
- Brake Shoe Replacement 54
- Brake Drum Maintenance 58
- Mounting Wheels 59
- Test and Adjust Brakes 59
- Troubleshooting 60
- Coulter/Disc Gang Performance 61
- General Performance 61
- Sweep/Shank Performance 62
- Brakes (Option) 63
- Problem Causes Solutions 64
- Retract Kit (Option) 65
- Appendix 66
- Torque Values Chart 67
- Tire Inflation Chart 68
- Appendix 65 69
- Appendix 67 71
- Warranty 73
- Salina, Kansas 67402-5060 USA 78
Related products and manuals for Gardening equipment Great-plains DVN8324 Operator Manual
(59 pages)
(36 pages)© 2020, manymanuals.com. All rights reserved. | 0.826 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals