Great-plains 4000TM Assembly Manual User Manual download pdf (Page 16)

12 1800-3000TM Table of Contents Index Great Plains Manufacturing, Inc.

586-536E Table of Contents Index 04/12/2013

Valve Brackets & Valves

Refer to Figure 10

Note: Bolts needed in these next steps will be bolted on parts

or located in a bag on front of center frame.

27. Remove the 1/2 x 3 1/32 x 6 u-bolts from the valve

brackets and , Attach bypass and counterbalance

valve bracket and lock valve bracket to center brace

bar in proper locations, shown, See “Valve Brackets &

Hoses” below, with the same 1/2 x 3 1/32 x 6 u-bolts , 1/

2 lock washers and 1/2 nuts.

28. Be sure hoses are routed as shown in, See “Valve Brack-

ets & Hoses” below.

29. Install bypass valve on top of valve bracket with 5/16

x 3 Gr. 5 hex bolts , 5/16 lock washers and 5/16 nuts.

30. Fasten the counter balance valve to side of valve

bracket with 5/16x4Gr.5hexbolts , 5/16 lock wash-

ers and 5/16 nuts.

31. Install the lock valve to the top of the valve bracket

with 1/4 x 2 Gr. 5 hex bolts , 1/4 lock washers and 1/4

nuts.

32. Fasten the two way fold valve to top of plate on tube of

center brace bar with 5/16 x 1 3/8 x 2 3/16 u-bolts

and 5/16 top lock nuts.

33. Attach depth control valve to top of depth stop bracket

(plunger forward), with 5/16 x 2 Gr. 5 hex bolts and 5/

16 lock washers.

34. Bolts may be tightened to specs, See “Torque Values

Chart” on page 38.

Valve Brackets & Hoses

Refer to Figure 11

Note: The hoses will be shipped hooked up to valves and cyl-

inders. The front valves and hoses (that will need rout-

ed through front brace bar, trusses and up hitch to

tractor) will be rolled up and tied to front of center frame

during shipping. The wing fold two way , bypass

and lock valves will need mounted in proper location

as shown and hoses routed correctly before front truss-

es and hitch are installed so front weight kits may be

installed or removed without taking hoses or valves

loose. The hoses need to route in locations shown with

arrows, on top of wing brace to outside of tubes then

back to inside. Install front trusses on top of hoses as

shown. The two valve plates will be mounted in correct

location but will need turned around 180 degrees on

tube so they are facing forward on machine. Set them

1” from truss plates as shown. See “Valve Brackets &

Valves” above, for proper mounting instructions.

Figure 10

Valve Brackets & Valves

43113

1 2

1 8

9 2

Figure 11

Valve Brackets & Hoses

43112

1 2

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 63 64

Comments to this Manuals

No comments

Great-plains 4000TM Assembly Manual User Manual Page 16

Comments to this Manuals

Related products and manuals for Gardening equipment Great-plains 4000TM Assembly Manual