Great-plains 4000TM Assembly Manual User Manual download pdf (Page 24)

20 1800-3000TM Table of Contents Index Great Plains Manufacturing, Inc.

586-536E Table of Contents Index 04/12/2013

Center Gang Bar 1800

Note: Refer to center gang bar assembly in “Parts Man-

ual” for correct part numbers of all components.

Refer to machine layout drawings in this manual

for correct gang assembly placement.

Refer to Figure 19

73. Position gang assemblies in proper locations.

Install the gang pivot bolt through tubes of gang

bars and tubes on center frame, secure with 1 1/4

ﬂat washers (one on top and one on bottom), 1 1/

4 slotted nut (one on top and one on bottom).

Tighten bolts snug, torque to 350 to 400ft-lbs. Install

the 3/16 x 2 cotter pins through 1 1/4 slotted nuts

and bend over to secure.

Note: Be sure turnbuckle assembly is preset at 62”

before installing as shown below. See gang angle

adjustment in “Operator Manual” before going to

ﬁeld.

74. Install turnbuckle assembly , adjustable end on ear

on front of rear gang bars and ﬁxed end on ear of

front gang bars. Secure with 1 x 3 1/4 clevis pin ,

1.5 x 1.00 x 0.075 machine washer and 3/16 x 2

cotter pin .

75. Install the round tubes (two on each gang bar)

between bottom front plate (slotted hole toward

rear), rear plates and plates on center frame.

Install the 3/4 x 6 hex bolts , 3/4 lock washers and

3/4 nuts. Attach other ends of plates and to

bottom of center frame with 3/4 x 2 hex bolts and

3/4 lock washers.

76. Install bracket on bottom side of gang bar plate,

secure with 5/8 x 3 1/2 hex bolts , 5/8 lock wash-

ers and 5/8 nuts.

77. Now the gang cylinders may be hooked up with

the 1 x 3 1/8 clevis pin , 1.5 x 1.00 x 0.075

machine washer and 3/16 x 2 cotter pin .

78. Bolts may be tightened to specs, See “Torque Val-

ues Chart” on page 38 and all cotter pins may be

bent.

8 5

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 63 64

No comments

Great-plains 4000TM Assembly Manual User Manual Page 24