Great-plains DVN8324 Operator Manual User Manual download pdf (Page 45)

Great Plains Manufacturing, Inc. Operating Instructions 41

11/25/2013 550-466M

Coil Tine Settings

Refer to Figure 34

b.On coil tine drags start with the top eyebolt (1) cen-

tered. Then level drag mainframe (2) by changing

position of leveling bolts (3). There are two holes in

the arm and four in the mainframe. One of these will

get you where you need to be to be level. To lay teeth

back, remove the clip pin (4) on each end and move

strap adjustment by pushing the handle (5) forward.

The strap has 5 holes arm will let you lay the teeth

back several degrees. If it is desired to set one row,

usually the ﬁrst, different than the rest as far as the

angle is concerned, it can be adjusted individually by

loosening the u-bolt and set-screw on each end of

the drag bar. Down pressure on the drag is achieved

by lengthening the eyebolt (1) on the top bracket.

Depending on the amount of down pressure, you

may need to re-level the mainframe.

Reel Settings

c.If a reel is added, adjust the amount of down pressure

by either shortening the eyebolt for less pressure or

lengthening for more pressure.

Parking

Follow these steps when parking the implement for periods

of less than 36 hours. For longer periods, see Storage, the

next topic.

1. Position the implement on ﬁrm, level ground.

2. Raise, fold and lock implement (page 28 and page 24).

Note: Static tongue weight of a loaded, lowered, and

unhitched implement can be as much as 500 kg

(1100 lb))

Refer to Figure 35

3. Remove jack from storage position and pin securely

to lifting stob on outside of implement tongue . See

“Hitching Tractor to Discovator” on page 17.

4. If ground is soft, place a wide block or plate under the

jack to increase contact area.

5. Securely install chock blocks to prevent jack from dig-

ging or sliding off plate.

6. For dual line air brakes, disconnect the red (control)

gladhand connector ﬁrst, at the tractor, then the blue

supply connector, and store each connector in its

matching color-coded gladhand holder on the imple-

ment.

7. Un-hook electrical lines and protect with any plugs or

caps provided.

8. Release pressure on hydraulic system, then discon-

nect hydraulic lines and pull all lines back onto imple-

ment tongue. Store hoses ends in keyholes of hose

holder bracket.

9. Disconnect hydraulic brake line (option).

10. Disconnect the safety chain.

11. Unhitch from tractor or leading implement.

Figure 34

Coil Tine Settings

41373

Figure 35

Jack (Parking)

42184

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 77 78

Comments to this Manuals

No comments

Great-plains DVN8324 Operator Manual User Manual Page 45

Comments to this Manuals

Related products and manuals for Gardening equipment Great-plains DVN8324 Operator Manual