Great-plains NTA3007HD Predelivery Manual User Manual download pdf (Page 45)

Assembly 41

03/29/2010 166-207Q

Refer to Figure 74

Step 3:

1. Coat pivot holes in frame with antisieze com-

pound.

2. Put shim stack (from Step 2) over pivot hole (be

sure to have nuts facing up).

3. Align wing fold weldment over hole .

4. Put shim stack (from Step 2) over top hole in wing

fold weldment (be sure to have nuts facing down).

5. Install pin from bottom up.

6. Install washers and hand thread on nut .

7. This will allow you to turn pin and align cross hole

at bottom of pin with frame.

8. Put cross bolt in and tighten. Tighten nut to

135 ft. lb torque. Install cotter pin.

Refer to Figure 75

Step 4: Wing Pivot:

1. Coat holes in wings with antisieze compound.

2. Align holes in wing with hole in fold arm .

3. Slide 2 shims between wing and front of arm.

4. Begin to slide pin in. With pin approximately half

way in slide 2 shims between the back side of the

fold arm and wing. Continue to slide pin in.

5. Install washers and hand thread on nut .

6. This will allow you to turn pin and align cross hole

in pin with wing frame.

7. Put cross bolt in and tighten. Tighten nut to

135 ft. lb torque. Install cotter pin.

Figure 74

Wing to Main Frame

31148

A 6

7 6

910

Figure 75

Wing to Fold Arm

31148

13 12

17 18

19 18

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 69 70

No comments

Great-plains NTA3007HD Predelivery Manual User Manual Page 45