Great-plains NTA3510 Installation Instructions User Manual download pdf (Page 23)

Great Plains Mfg., Inc.

Installation Instructions 23

10/29/2008 168-414M

NTA-3510 Installation

This installation requires one of the following kits:

168-406A NTA3510-5575 (55 row, 7.5in)

168-407A NTA3510-4010 (40 row,10in)

Additional installation information is found in the

DICKEY-john IntelliAg Air Cart Control Operator’s man-

ual.

Note: The DICKEY-john manual has only general har-

ness routing for the Great Plains air drills, and

some cable part numbers are slightly different from

those in the kits.

Continuing from step 8 on page 3.

Refer to Figure 51 and Figure 52

9. Select ﬁve (5):

168-465D DIST TOWER MODULE MOUNT PLATE

At each tower, remove the nuts and lock washers

at the lower U-Bolt , and mount the plate .

Plate orientation is small holes to top, and

, : plate to drill center,

: plate to drill rear.

NTA35: Install WSMBs

Start with the left tower (Tower 1).

10. Select one:

467981100S1 INTAG WSMB/FLW MNTR MODULE 18R

and two sets:

802-224C HHCS 1/4-20X1 1/4 GR5

804-006C WASHER LOCK SPRING 1/4 PLT

803-006C NUT HEX 1/4-20 PLT

Mount the WSMB on the tower side of the plate

, with the mounting ears ﬂush against the plate

and the connector ports facing down.

11. Repeat step 10 for the remaining towers

Figure 51

NTA 3510 Tower Arrangement

29020

2 312

T1 T5

T2 T4

Figure 52: NTA35:

Module Mount

27058

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 41 42

Comments to this Manuals

No comments

Great-plains NTA3510 Installation Instructions User Manual Page 23

Comments to this Manuals

Related products and manuals for Gardening equipment Great-plains NTA3510 Installation Instructions