Great-plains NTA3510 Installation Instructions User Manual download pdf (Page 3)

Great Plains Mfg., Inc.

Installation Instructions 3

10/29/2008 168-414M

Pre-Assembly Preparation

Work Location

1. Move the drill to a location with:

• room to unfold it,

• adequate illumination, and;

• a clear surface beneath for recovery of any

dropped parts.

Prepare Drill

2. Position the drill at the work location.

3. Unfold the drill.

4. Lower the row units.

5. Set tractor hydraulic remotes to Float, to relieve

pressure in the lines.

Port Numbering

Tower Ports are numbered Clockwise from mount center

(Port 1) to the last port number, which is the same for all

towers on the same drill.

As an aid to installation, mark the port numbers after

checking Port 1. If the tower weldment has shifted posi-

tion since initial delivery, Port 1 may not be exactly at the

mount.

Refer to Figure 3

6. Verify Port 1. Consult the Port Assignments table

for the drill and row spacing (found in the Appendix

of this manual). The ﬁrst Opener entry in the table is

Port 1. Openers are numbered from 1 at drill left.

Follow the seed hose from that opener to the tower.

This is Port 1.

7. Mark the Port numbers on the tower cap, moving

clockwise (looking down on the cap) from Port 1.

8. Turn to pages for your drill:

3N-4010HDA Installation.....................................page 4

CTA-4000 and 4000HD Installation...................page 10

NTA-3010 Installation ........................................page 17

NTA-3510 Installation ........................................page 23

Figure 3

Tower Port Numbering

Facing Tower At Mount

28185

PORT

PORT 2

PORT 8, 9, 10, 11,

12, 13 or 16

1 2 3 4 5 6 7 8 ... 41 42

Comments to this Manuals

No comments

Great-plains NTA3510 Installation Instructions User Manual Page 3

Comments to this Manuals

Related products and manuals for Gardening equipment Great-plains NTA3510 Installation Instructions