16
Simba SL700
603-216M-ENG
2013-01-25
4. Raise the drawbar and move the
parkingstandtoitstransportposition.
5. Carefully operate the hydraulics to
lowerthedrawbarandtilttheSL700
ontotheroadtransportwheels.Extend
the drawbar cylinder and lift axle
cylinderenoughtoaddintherequisite
amount of shims for road transport.
Ordinarilya51mmsilvershimineach
liftcylindershouldbeusedtogivea
transportheightof3930mm,however
themachinecanbetransportedwithout
shimsintheliftcylindersprovidedthat
roadconditionsaresuitable(thisgives
atransportheightof3850mm).
6. Ensurethatthewinglockisengaged
correctly before transporting the
machine.
7. If the machine is already folded it
is proceed to the next step. If the
machine is unfolded please refer to
2.5.2.
8. Remove the wheel chocks and stow
asshownonpage50.
2.4 Hitching Up
2.4.1 Hitching up a Tractor
to the SL700 / Preparing for
Transport
When hitching-up the machine,
ensurethatno-oneisbetweenthe
tractorandthemachine.
When the SL700 is parked for
extendedperiodsoftimeitshould
ideally be left in the unfolded,
i.e. work position for stability,
safety and ease of access for
maintenance. However, parking
the SL700 in the folded position
(ensuring the transport lock is
engaged) is acceptable in the
normalcourseofoperation.
Tractor Oil Flow Adjustment:
As a general rule the tractor oil
flow rate should be set in the
lowest setting before starting.
This can then be increased to
allowthedesiredrateofoperation
as applicable. This will minimise
excessiveoilowandconsequent
powerusageandheatgeneration.
1. Ensure the tractor hydraulics are
depressurised and in the locked or
closed(notoat)setting.
2. Couple the hydraulic hoses to the
tractor ensuring that the two wing
hoses(yellow)aretogether,thetwo
drawbar cylinder hoses (red) are
together,thetineframehoses(green)
and the rear roll hoses (blue) are
together.
3. Connect the tractor to the drawbar
usingthehydraulicstoraiseorlower
theheightoftheshackle.Donotuse
thetractorpick-uphitchtoattachthe
machinetothetractor.
Fig. 2.02: Transport Lock
2.Transportation/Installation
Fig. 2.01: Parking Stand
Handle
9
Å
Å
1
3
2
1.Removepin
2.Rotatestandup
3.Re-insertpin
Comments to this Manuals