Great-plains VARIABLE RATE KIT Operator Manual User Manual download pdf (Page 4)

4 Air Drill Variable Rate Kit Front Parts Great Plains Mfg., Inc.

166-263M Front Parts 6/23/2010

Update Monitor Software

For models NTA607HD, NTA907HD, NTA2007HD or

NTA3007HD, continue at step 18 on page 5.

This step is performed ﬁrst in the unlikely event that there

is any incompatibility between your IntelliAG

virtual ter-

minal, and the latest version of the Air Cart Control soft-

ware supplied in the kit.

If you are unable to update the seed monitor system, do

not continue the update. Have your Great Plains dealer

contact the factory for assistance.

Refer to Figure 3

8. Check the seed monitor Software Version per the

11001-1507 guide. If the Software Version

is:

4.21 or higher,

you do not need to update the seed monitor soft-

ware. If no update is required, continue at step 18

on page 5.

9. If you require a software update, and the SD card is

missing from the kit, contact Great Plains to obtain

the update.

10. Select from the kit one new:

11001-1507 ACC V4 SOFTWARE REPROGRAMMING

This is a DICKEY-john

manual describing the pro-

cess of updating the software for the virtual terminal

(if needed) and the WSMT (if needed).

11. Follow the instructions in the reprogramming

manual to check the VT part number (on back of

terminal) and the software version of your seed

monitor (icon ).

12. Record Current Conﬁguration

Monitor conﬁguration may reset to defaults during

update. If either VT or WSMT will be updated,

record the current air drill conﬁguration, particularly

the Material Library. Although newer virtual termi-

nals support exporting the conﬁguration to a blank

SD card, Great Plains recommends making a paper

record, as an imported SD conﬁguration may be

altered during Auto Conﬁg at step 79.

13. Select from the kit one new:

INTELLI-AG SOFTWARE UPDATE SDC

This is a small Secure Digital (SD) ﬂash memory

card. When instructed, the card is inserted in a

slot at the lower right corner of the VT bezel, behind

a ﬂip-up door .

14. Select one each new from the kit:

110011512 ACC USR MANUAL VER 4.2 LVL 2&3

110011513 ACC USER MANUAL VER 4.2 LVL 1

The new software introduces user access levels,

and requires a password, described in the Pass-

word Access manual .

15. Follow the instructions in the reprogramming

manual . Software is already provided on a for-

matted SD card, so perform no steps calling for:

- media formatting or

- extranet downloading.

16. The new variable rate controller is not yet installed,

and will not be detected by the new software. After

installing the new hardware, a complete Setup/Con-

ﬁguration is performed starting on page 15 of these

instructions.

17. Shut down the monitor. Shut off the tractor ignition

(to assure that monitor circuits are powered off).

a. This is displayed as “Software Version” and is not the “O.S. Version” nor the “Bootloader Version”.

Figure 3

10in Virtual Terminal and SD Card

29504

1 2 3 4 5 6 7 8 9 ... 21 22

Comments to this Manuals

No comments

Great-plains VARIABLE RATE KIT Operator Manual User Manual Page 4

Comments to this Manuals

Related products and manuals for Gardening equipment Great-plains VARIABLE RATE KIT Operator Manual