Great-plains VARIABLE RATE KIT Operator Manual User Manual download pdf (Page 9)

Great Plains Mfg., Inc. Front Parts Installation Instructions 9

6/23/2010 Front Parts 166-263M

Install NTA607/2007HD Arm(s)

For ADC/NTA907/3007HD, install arms per step 29

through step 35 on page 8, then continue at step 45 on

page 10.

Refer to Figure 11

(which depicts an ADC installation - the NTA installations

have a different appearance but use the same instructions)

37. Select one new:

168-370H ELECTRONIC CONTROL ARM WLDMNT

and two new:

890-202C

GAUGE WHEEL SFT PIVOT BUSHING

38. Press one bushing into the inside end of the

control arm tube (the side with the longer arm with

indicator point).

Using the existing

⁄

in holes in the tube as a guide,

drill a

⁄

in hole through both sides of the bushing.

39. Press the other bushing into the outside end of

the control arm tube.

40. With indicator tip to rear, and toward gearbox, place

arm weldment assembly on control shaft .

41. Select one saved:

805-065C PIN WIRE RETAINING 1/4 X 1 3/4

Align the arm tube and inside bushing with

the hole in the gearbox control shaft. The arm

indicator tip should be pointing near “0” on the

scale.

Secure the arm with the wire retaining pin .

42. Select one each new:

805-021C PIN COTTER 1/4 X 2 PLT

Insert the cotter pin through the end holes of the

gearbox control shaft. Spread tips to secure cotter.

43. If two meters are being upgraded, repeat step 37

through step 42 for the other meter.

44. Continue at step 50 on page 10.

Figure 11

Install Control Arm

31358

40 8

16 9

840

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 21 22

Comments to this Manuals

No comments

Great-plains VARIABLE RATE KIT Operator Manual User Manual Page 9

Comments to this Manuals

Related products and manuals for Gardening equipment Great-plains VARIABLE RATE KIT Operator Manual