Great-plains YP825AR Operator Manual User Manual Page 159
- Page / 166
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Great Plains Manufacturing, Inc. Table of Contents Index Appendix C - Initial Setup 155
2014-06-17 Table of Contents Index 401-923M
Liquid Fertilizer Drop Lines (Option)
Booms are identical for single-row and twin-row planters.
For single-row use, and if planting single-row on a
twin-row planter, half of the nozzles are shut off.
Drop lines are not factory-installed, and may not be
dealer-installed, because there can be multiple possible
applicator connection points, including:
• frame-mounted coulter applicator
• 25AP Series nut bar applicator
• seed firmer applicator
• press wheel dribbler
Install Caps on Taps
Refer to Figure 137
1. Determine which manifold taps are to be active,
and which shut off.
2. For each active row, select one:
832-051C NOZZLE CAP QUICK X 90X1/4 FNPT
Align the nozzle with the manifold tube . Press
down and rotate 90°.
Note: Nozzles may face forward or back, at user
preference.
Note: Orifice plates may be installed prior to capping, if
the size is known.
3. For each shut-off row, select one:
832-042C NOZZLE SHUT OFF CAP W/ GASKET
Press cap down and rotate 90°.
Install Drop Lines to Rows
Drop line tubing is supplied on one or more uncut
coils:
990-109R TUBE NYLON 1/4OD X 062WL
Lengths are cut for each active nozzle.
4. Route tubing and cut. Routing goals are:
5. At the nozzle end, if the tubing adaptors are not
already installed, select one:
800-367C AD PUSH 1/4TUBEX1/4MNPT
Apply liquid pipe thread sealant. Thread the
adaptor into the nozzle .
Insert the drop line tube into the adaptor .
6. At the application end, select one:
830-383C CP 1/4 PUSH LOK POLY
Confirm that the coupler is required for, and
compatible with, the style of applicator. Push the
coupler onto the applicator tube. Push the drop
line tube into the coupler.
Note: When the coupler is not used, typically with
1
⁄
2
inch O.D. steel applicator tubes, push the drop
line tubing entirely through the applicator tube,
leaving
1
⁄
2
inch to
3
⁄
4
inch of tubing length
exposed. Tie wrap the tubing near the top of the
applicator tube.
Figure 137
Drop Line Detail
31002
74
1
75
3
2
78
65
73
1
75
75 2
3
74
74
• Allow slack at the nozzle for nozzle removal and
orifice plate changes.
• Route to avoid planter moving parts which could
cause tubing damage.
• Route for continuous down slope - avoid low spots
in tubing.
• Allow slack along the route to anticipate coulter or
row unit vertical range of motion.
• Secure the tubing with tie-wraps only where
planter operations can’t cause tubing movement.
78
78 65
65 75
78 65
73
73
73
78
- Operator Manual 1
- Table of Contents 3
- Important Safety Information 5
- Wear Protective Equipment 6
- Avoid High Pressure Fluids 6
- Use A Safety Chain 7
- Keep Riders Off Machinery 7
- Use Safety Lights and Devices 7
- Transport Machinery Safely 7
- Shutdown and Storage 8
- Tire Safety 8
- Handle Chemicals Properly 8
- Practice Safe Maintenance 9
- Safety At All Times 9
- Safety Decals 10
- READ BEFORE USING TANK 11
- EXCESSIVE SPEED HAZARD 12
- 848-801C 14
- Introduction 15
- Using This Manual 16
- Owner Assistance 16
- Preparation and Setup 17
- Hitching Tractor to Planter 18
- Hydraulic Hose Hookup 20
- Air Source Setup (Option) 21
- Leveling Planter 22
- Monitor Setup 24
- Marker Setup (Option) 24
- Lock Up Fertilizer Drive 25
- Operating Instructions 26
- Transport 27
- Transport Steps 28
- Color Function 29
- CLOSED OPEN 30
- Unfolding/Folding the Planter 31
- 34702-04 34
- Field Lift/Lower 39
- Marker Operations 40
- Loading Materials 41
- Loading Seed, continued 42
- Air System Operation 49
- 848-020C 52
- Meter Operation 53
- Field Set-Up Checklists 54
- Field Operation 55
- Short-Term Parking 56
- Long-Term Storage 56
- Adjustments 57
- Setting Material Rates 58
- Marker Adjustments (Option) 59
- Fan and Gauge Adjustment 60
- Single-Row Augers 64
- Row Implement Adjustments 66
- Row Unit Down Pressure 70
- UMC Coulter Adjustments 73
- Side Gauge Wheel Adjustment 76
- Row Unit Shut-Off 82
- Seed Firmer Adjustments 84
- Troubleshooting 87
- Seed Pool Troubleshooting 88
- Problem Cause Solution 89
- Population Too Low 90
- Population Too High 91
- Population Related 93
- General Troubleshooting 94
- Maintenance and Lubrication 99
- Material Clean-Out 100
- Liquid Fertilizer Clean-Out 102
- Dry Fertilizer Clean-Out 103
- Hydraulic Maintenance 109
- As Required 112
- 25474 25475 116
- Seasonal 118
- Seed Lubricants 120
- Seed Monitor 121
- Seed Meter Drive 121
- PTO Pump 122
- Speed Radar 124
- Liquid Fertilizer System 124
- Dry Fertilizer System 125
- Dual Sequenced Markers 126
- Frame-Mounted Row Accessories 126
- Terra-Tine™ 127
- Row-Mounted Accessories 128
- Unit-Mounted Disk Coulters 129
- Seed Meter Disks 129
- Inside Disk Scrapers 130
- Gauge Wheel Scrapers 130
- Seed Firmers 130
- Row Unit Press Wheels 131
- Lock-Up Pins 131
- Seed Lubricant 131
- Clean-Out Container 132
- Seed Tube Brush 132
- Specifications and Capacities 134
- 70 and 75 cm Models 135
- Dimensions 136
- Field Dimensions 137
- Torque Values Chart 138
- Tire Inflation Chart 138
- Plumbing Diagrams 139
- Hydraulic Diagrams 140
- Chain Routing 149
- Twin Row Single Row 151
- 15T, 47T 152
- 25AP: Meter Drive (Mid type) 153
- 25AP: Meter Drive (Rear type) 153
- Appendix C - Initial Setup 154
- Marker Extension 155
- 122-278S Scraper Installation 158
- NOZZLE SHUT OFF CAP W/ GASKET 159
- Table of Contents Index 165
- Salina, Kansas 67402-5060 USA 166
Related products and manuals for Gardening equipment Great-plains YP825AR Operator Manual
(8 pages)
(50 pages)
(128 pages)© 2020, manymanuals.com. All rights reserved. | 0.922 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals