Great-plains ADC2350BE Operator Manual User Manual Page 40
- Page / 108
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
36 ADC2350/E and ADC2350B/BE Table of Contents Index Great Plains Manufacturing, Inc.
167-085M Table of Contents Index 2012-08-01
Meter Hand Crank
A hand crank is provided on the left side of the cart for
manual operation of the meters (the meters otherwise
turn only when the cart is in motion with the clutch
engaged).
Equipment Damage Risk:
Rotate the hand crank only in the counter-clockwise direction,
as shown in Figure 32. Operating in reverse (clockwise) can
cause meter gear box damage.
The crank is used for two common tasks:
• calibration of the meter setting for planting, and
• clean-out of the meter flute chamber.
Installing Crank
Refer to Figure 31 and Figure 32
6. Remove the pin from the crank shaft behind the
outer crank bracket.
7. Pull the crank out of the inside bracket (only)
and slide the end of the crank shaft onto the outside
end of the meter jackshaft . Re-insert the pin in the
crank shaft so it doesn’t get lost.
Operating the Hand Crank
Refer to Figure 32
Turn the hand crank counter-clockwise to simulate meter
operation during planting.
Specific recommendations may be made in applicable
manual sections. See:
see “Meter Calibration” in the Seed Rate manual,
see “Unloading the Cart” on page 47, and
see “Storage” on page 55.
In general, you may operate the crank as fast as is
comfortable. For reference, at a field speed of 6 mph, the
jackshaft rotates at 150 rpm (2.5 turns per second).
For clean-out, make sure the variable rate gearboxes
are set:
• above “10” if the final drive range gears are in
High Range mode, or
• above “80” if the final drive range gears are in
Low Range mode.
To change variable rate gearbox and final drive range
gearing see “Setting Material Rates” on page 56.
Note: If variable rate gearbox is set to “0”, operating the
hand crank may fail to clear the meters of seed.
Figure 31
Hand Crank Storage
26333
1
2
3
4
1
2 3
4
Figure 32
Hand Cranking Direction
26333
5
5
- Operator Manual 1
- Table of Contents 3
- Important Safety Information 5
- Avoid High Pressure Fluids 6
- Use A Safety Chain 6
- Keep Riders Off Machinery 6
- Use Safety Lights and Devices 6
- Check for Overhead Lines 7
- Transport Machinery Safely 7
- Wear Protective Equipment 7
- Handle Chemicals Properly 8
- Confined Space 8
- Shutdown and Storage 8
- Practice Safe Maintenance 9
- Tire Safety 9
- Safety At All Times 9
- Safety Decals 10
- 838-266C 11
- Red Reflectors 11
- 838-265C 11
- Amber Reflectors 11
- 838-267C 12
- Daytime Reflectors 12
- 818-557C 12
- Danger: Cannot Read English 12
- EXCESSIVE SPEED HAZARD 14
- 818-339C 15
- 818-622C 15
- Introduction 19
- Using This Manual 20
- Owner Assistance 21
- Preparation and Setup 22
- Cart Drive System 23
- Hitching 24
- Color Hydraulic Function 28
- 817-348c 29
- Set Up the Implement 32
- Row Setup Data 33
- Operating Instructions 35
- Walkboard Ladders 36
- Hopper Lids 37
- Strainer 38
- Meter Doors 39
- Meter Hand Crank 40
- Drive Chain Lockout 41
- Auger Operations 42
- Transport 45
- Monitor Material Configuration 47
- Loading Material 48
- Cart Diverter Valve 49
- Unloading the Cart 51
- Unloading Front Hopper 53
- Unloading Rear Hopper 54
- Unloading Closeout 56
- Field Operations 57
- Final Field Checklist 58
- Planting Sequence 58
- Planting 58
- Adjustments 60
- Hoppers for This Material 62
- Single Dual 62
- Meter Rate Adjustment 64
- FINAL DRIVE 65
- DRIVING DRIVEN 65
- Changing Meter Flutes 70
- Fan Speed Adjustment 72
- 3N-4010HDA Lift Switch 73
- Clutch Lock-Up 74
- Troubleshooting 75
- Excessive seed 77
- Problem Cause Solution 77
- Maintenance and Lubrication 78
- Chain Slack 79
- Problem Clean-Outs 81
- Hopper Entry 82
- As Required 85
- Seasonal 87
- Blockage Detector 88
- 10 inch Seed Monitor Console 88
- Alternate Flute Sets 89
- ADC2350/E Hitches 90
- Variable Rate Control 90
- Appendix 91
- Torque Values Chart 92
- Chain Routing 93
- Hydraulic Diagrams 94
- ADC2350/E Hydraulic Circuits 95
- Warranty 102
- Table of Contents Index 107
- Salina, Kansas 67402-5060 USA 108
Related products and manuals for Gardening equipment Great-plains ADC2350BE Operator Manual
(54 pages)
(49 pages)© 2020, manymanuals.com. All rights reserved. | 0.340 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals