Great-plains ADC2350BE Operator Manual User Manual Page 58
- Page / 108
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
54 ADC2350/E and ADC2350B/BE Table of Contents Index Great Plains Manufacturing, Inc.
167-085M Table of Contents Index 2012-08-01
Refer to Figure 65
The proper reading for the magnehelic air pressure gauge is
12 to 25 inches of water. A sudden drop in pressure is a sign of
a possible leak which can negatively affect seeding.
Final Field Checklist
Planting Sequence
1. Lower drill 5 to 10 feet before initial seeding point.
2. Pull forward and begin planting.
3. Raise drill for turns (meters stop automatically).
Planting
Be aware of the 5 to 10 feet of drill-lowered operating
distance required for seed to reach the row units.
If you stop in the middle of a pass, raise the drill and back
up 10 feet before resumption of seeding.
Parking
Follow these steps when parking the drill for periods of
less than 36 hours. For longer periods, see Storage, the
next topic.
1. Place the cart on firm, level ground.
2. Check that hopper lids are latched, and secure the
hopper lids with security cable or padlock and chain
to prevent entry by children. See “Lid Closing” on
page 33.
3. ADC2350/E only: Remove jack from storage position
and pin securely to lifting stob on outside of cart
tongue. See “Hitching” on page 20.
4. ADC2350/E only: If ground is soft place a wide block
or plate under the jack to increase contact area.
5. Securely block cart tires to prevent rolling.
6. ADC2350/E only: Extend jack until weight is off of
the tractor drawbar.
7. Unhook electrical lines and install plugs as provided.
8. Release pressure on hydraulic system, then
disconnect hydraulic lines and pull all lines back onto
cart tongue. Be sure hose ends do not rest on the
ground.
9. Disconnect the safety chain.
10. Unhitch from tractor or leading implement.
Figure 65
Fan Air Pressure
26425
❑ Set seed meters per chart and calibration.
❑ Check diverter valve set to marker or fan.
Check fan shut-off valve open (fan enabled)
❑ Set fan to speed suitable for seed. Watch fan at
start-up to ensure correct direction of rotation.
❑ Run fan for at least 15 minutes before planting.
❑ Check air pressure gauge for 12 to 25 inches of
water pressure.
❑ Check all seed hoses secure.
❑ Check for air leaks at lids and meter box seals.
❑ Complete drill checklist.
- Operator Manual 1
- Table of Contents 3
- Important Safety Information 5
- Avoid High Pressure Fluids 6
- Use A Safety Chain 6
- Keep Riders Off Machinery 6
- Use Safety Lights and Devices 6
- Check for Overhead Lines 7
- Transport Machinery Safely 7
- Wear Protective Equipment 7
- Handle Chemicals Properly 8
- Confined Space 8
- Shutdown and Storage 8
- Practice Safe Maintenance 9
- Tire Safety 9
- Safety At All Times 9
- Safety Decals 10
- 838-266C 11
- Red Reflectors 11
- 838-265C 11
- Amber Reflectors 11
- 838-267C 12
- Daytime Reflectors 12
- 818-557C 12
- Danger: Cannot Read English 12
- EXCESSIVE SPEED HAZARD 14
- 818-339C 15
- 818-622C 15
- Introduction 19
- Using This Manual 20
- Owner Assistance 21
- Preparation and Setup 22
- Cart Drive System 23
- Hitching 24
- Color Hydraulic Function 28
- 817-348c 29
- Set Up the Implement 32
- Row Setup Data 33
- Operating Instructions 35
- Walkboard Ladders 36
- Hopper Lids 37
- Strainer 38
- Meter Doors 39
- Meter Hand Crank 40
- Drive Chain Lockout 41
- Auger Operations 42
- Transport 45
- Monitor Material Configuration 47
- Loading Material 48
- Cart Diverter Valve 49
- Unloading the Cart 51
- Unloading Front Hopper 53
- Unloading Rear Hopper 54
- Unloading Closeout 56
- Field Operations 57
- Final Field Checklist 58
- Planting Sequence 58
- Planting 58
- Adjustments 60
- Hoppers for This Material 62
- Single Dual 62
- Meter Rate Adjustment 64
- FINAL DRIVE 65
- DRIVING DRIVEN 65
- Changing Meter Flutes 70
- Fan Speed Adjustment 72
- 3N-4010HDA Lift Switch 73
- Clutch Lock-Up 74
- Troubleshooting 75
- Excessive seed 77
- Problem Cause Solution 77
- Maintenance and Lubrication 78
- Chain Slack 79
- Problem Clean-Outs 81
- Hopper Entry 82
- As Required 85
- Seasonal 87
- Blockage Detector 88
- 10 inch Seed Monitor Console 88
- Alternate Flute Sets 89
- ADC2350/E Hitches 90
- Variable Rate Control 90
- Appendix 91
- Torque Values Chart 92
- Chain Routing 93
- Hydraulic Diagrams 94
- ADC2350/E Hydraulic Circuits 95
- Warranty 102
- Table of Contents Index 107
- Salina, Kansas 67402-5060 USA 108
Related products and manuals for Gardening equipment Great-plains ADC2350BE Operator Manual
(54 pages)
(49 pages)© 2020, manymanuals.com. All rights reserved. | 1.249 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals