Great-plains ADC2350BE Operator Manual User Manual download pdf (Page 56)

52 ADC2350/E and ADC2350B/BE Table of Contents Index Great Plains Manufacturing, Inc.

167-085M Table of Contents Index 2012-08-01

Unloading Closeout

29. Remove pin from hand crank shaft, return hand

crank to storage position, and re-pin.

30. If storing at end of season, or having residual

material in the auger tube is a concern, reverse the

directional control on the auger until no seed

remains in the auger tube.

31. Set the tractor circuit for the auger to neutral, or shut

down tractor hydraulics completely.

Refer to Figure 37 on page 39

32. With auger circuit off, set diverter handle back

(pass-through to markers or fan).

Do not move the auger hydraulic diverter valve to the forward

position until the hydraulic circuit has been shut off at the

tractor. If the diverter is moved with hydraulics on, the drill

markers will suddenly begin moving.

Refer to Figure 62

33. Clean out auger hopper by pulling up the hopper

snap pin and swiveling the hopper to the side.

34. When empty, fold the auger swing arm (middle pivot

forward), and move it nearly into the cradles.

35. Swivel the auger hopper for transport or storage.

See “Storing Auger” on page 40.

36. Return auger to storage cradle. See “Storing

Auger” on page 40.

37. If removed, re-attach lower ladder. See “Removing

the Right Ladder” on page 32.

38. Wipe top and bottom of meter-box seal ﬂanges,

making sure all material is removed. Look for

material caught between seal and ﬂange.

39. Close clean-out and calibration doors. Close and

latch bulk hopper lids if they were open for

unloading.

Figure 62

Empty Auger Hopper

26331

1 2

Figure 63

Checking Meter Box Seals

26341

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 107 108

No comments

Great-plains ADC2350BE Operator Manual User Manual Page 56