Great-plains TSF1290 Operator Manual User Manual Page 42
- Page / 96
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
38 TSF1080, TSF1090, TSF1280 & TSF1290 Great Plains Manufacturing, Inc.
500-641M 05/10/2012
Transporting
1. Position your sprayer in an open area where you will
not hit power lines, buildings, etc. when the boom is
folded.
2. If transporting empty, do at least fill the hand wash
tank. See “Filling Hand Wash Tank” on page 42.
3. Check that the tractor is capable of towing the
sprayer. The sprayer must weigh no more than 150%
of the tractor weight. The tractor must be rated for
the load. See table at right for sprayer configurations.
4. Make sure the safety chain is securely fastened to
the tractor draw bar and the retaining clip is fastened
to the hitch pin.
5. Never allow riders when transporting the sprayer.
6. When transporting your sprayer, be sure to watch the
height clearances of your folded boom to prevent
damage to the boom and possible injury.
Contact with electrical power lines can cause death by electro-
cution.
7. Do not exceed 20 mph (32 kph) while transporting
your sprayer.
8. Do not transport sprayer while filled with chemical
mixture.
Note: If a suitable water source exists at the field, trans-
port the sprayer with main tank empty. The weight
of the sprayer more than doubles when the main
tank is full.
Plumbing Overview
Refer to Figure 28
A basic knowledge of how the sprayer is plumbed helps
you understand how to operate your Great Plains
Sprayer. Throughout this manual, the components on
this diagram are described with the terminology labeling
these components.
Five of the valves are labeled on the sprayer decals.
Other key components are:
Agitator Selector Valve
Pump Inlet (Tank) Selector Valve
Fill/Spray Selector Valve
Product Valve (Tank Fill vs. Induct)
Inductor Valve (On/Off)
818 188C Rev C
Do Not exceed 20 mph maximum transport
speed. Loss of vehicle control and/or machine
can result.
To Prevent Serious Injury or Death:
EXCESSIVE SPEED HAZARD
WARNING
Sprayer Configuration Weight
TSF 1080, Empty 9290 lbs (4214 kg)
TSF 1080, Full 23390 lbs (10610 kg)
TSF 1090, Empty 9340 lbs (4237 kg)
TSF 1090, Full 23440 lbs (10632 kg)
TSF 1280, Empty 9760 lbs (4427 kg)
TSF 1280, Full 27385 lbs (12422 kg)
TSF 1290, Empty 9890 lbs (4486 kg)
TSF 1290, Full 27435 lbs (12444 kg)
Figure 27
Valve Setting Decal
838-700C
1
2
3
4
5
Main Tank
10
Flush Tank
Main Tank Sump
11
12
- Operator Manual 1
- Table of Contents 3
- Important Safety Information 5
- Wear Protective Equipment 6
- Handle Chemicals Properly 7
- Confined Space 8
- Use A Safety Chain 8
- Keep Riders Off Machinery 8
- Use Safety Lights and Devices 8
- Check for Overhead Lines 9
- Transport Machinery Safely 9
- Shutdown and Storage 9
- Practice Safe Maintenance 10
- Prepare for Emergencies 10
- Tire Safety 10
- Safety At All Times 11
- Safety Reflectors and Decals 12
- 818-265C 13
- Daytime Reflectors 13
- 818-267C 13
- Amber Reflectors 13
- 500-641M 05/10/2012 14
- 05/10/2012 500-641M 15
- EXCESSIVE SPEED HAZARD 17
- 818-381C 20
- 818-304C 20
- Introduction 21
- Owner Assistance 22
- Preparation and Setup 23
- Hitching with Hydraulic Pump 24
- Axle Spacing 25
- Electrical Connections 26
- Connection Comment 26
- Hydraulic Hookup 27
- Tractor / PTO Shaft Hookup 28
- Leveling Sprayer 29
- Locking System Setup 31
- Hydraulic Pump Setup 31
- Electrical Installation 32
- Raven SCS 450 33
- Hydraulic Valve Control 34
- Foam Marker Control (Option) 34
- Spraying Setup 35
- Manual Throttle Valve 36
- Sprayer Calibration 37
- Operations 40
- Using Hand Wash Tank 41
- Figure 28 44
- Sprayer Tank Plumbing 44
- Operations 41 45
- Figure 29 45
- Boom Plumbing System 45
- Filling Tanks 46
- Filling the Flush Tank 47
- Filling the Main Tank 47
- Adding Chemicals 50
- Inducting Chemicals (Option) 51
- Agitation 52
- Boom Operations 53
- Operating Pump 56
- Unloading Materials 56
- Tank and Boom Flush 57
- Adjustments 61
- Axle Wheel Spacing Adjustment 62
- Break Away Spring 63
- Troubleshooting 64
- Maintenance and Lubrication 66
- Filter Maintenance 67
- Shear Bolt 68
- Pump Maintenance & Repair 69
- Elevator Slide 73
- Quad-Jet Agitators 73
- Tank Entry 74
- Lubrication 75
- Seasonally 77
- Autoboom 78
- Axles and Wheels 78
- Calibration Accessories 79
- Chemical Inductor 79
- High Volume Foam Marker 79
- Gauge Protector 80
- Hitches (Hydraulic Pump Only) 80
- Open Center Hydraulic Kit 80
- Speed Sensors 82
- Appendix 83
- Torque Values 84
- Valve Port Function 85
- 60-Foot Sections 87
- Raven G1 Autoboom Hydraulics 88
- Warranty 89
- Tire Pressure and Torque 92
- Salina, Kansas 67402-5060 USA 96
Related products and manuals for Gardening equipment Great-plains TSF1290 Operator Manual
(5 pages)
(70 pages)© 2020, manymanuals.com. All rights reserved. | 0.656 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals